Search

Teseq CBA 230M-080

150 kHz – 230 MHz

150 kHz to 230 MHz 80 Watt Class A Solid State Amplifier

  • Class A linear and low distortion design
  • Ideal for IEC 61000-4-6 testing
  • Mismatch tolerant and unconditionally stable
  • Rugged design for EMC testing
  • Remote control option
  • Three year parts and labour warranty

Quick Enquiry

If you want to know more about Teseq CBA 230M-080
150 kHz – 230 MHz

Designed specifically for conducted EMC testing, this mismatch tolerant Class A amplifier is ideally suited to provide power into Bulk Current Injection (BCI) probes, injection clamps and CDN for IEC 61000-4-6 conducted susceptibility testing up to and beyond the normal 10 V emf test level.
The Class A design ensures a high reliability, low distortion linear performance across the frequency range. This design also ensures that the amplifier will continue to operate at full power even when presented with an open or short circuit at its output.

The unit is powered from a switched mode power supply for high efficiency, high power factor and wide voltage range operation. The unit is air-cooled with integral fans, and is protected against faulty cooling by excess temperature sensing. Front panel indicators are provided to indicate over-temperature.

Parameter Value
Frequency range (instantaneous) 150 kHz to 230 MHz
Rated output power 80 W minimum
Output power at 1 dB gain compression 70 W minimum
Small Signal Gain 50 dB
Harmonics at P1 dB -20 dBc
Power Supply Voltage 90-264 VAC
Power Supply Phases 1

 

Teseq CBA 230M-080 Datasheet