+31 40 7501650

Teseq CBA 230M-080

150 kHz to 230 MHz 80 Watt Class A Broadband Amplifier

  • Class A linear and low distortion design
  • Ideal for IEC 61000-4-6 testing
  • Mismatch tolerant and unconditionally stable
  • Rugged design for EMC testing
  • Three year parts and labour warranty
Contact us

Designed specifically for conducted EMC testing, this mismatch tolerant Class A amplifier is ideally suited to provide power into Bulk Current Injection (BCI) probes, injection clamps and CDN for IEC 61000-4-6 conducted susceptibility testing up to and beyond the normal 10 V emf test level.

The Class A design ensures a high reliability, low distortion linear performance across the frequency range. This design also ensures that the amplifier will continue to operate at full power even when presented with an open or short circuit at its output.

The unit is powered from a switched mode power supply for high efficiency, high power factor and wide voltage range operation. The unit is air-cooled with integral fans, and is protected against faulty cooling by excess temperature sensing. Front panel indicators are provided to indicate over-temperature.

Parameter Value
Frequency range (instantaneous) 0.15 to 230 MHz
Rated output power 80 W minimum (90 W typical)
Output power at 1 dB gain compression 70 W minimum (80 W typical)
Gain 50 dB
Harmonics at P1 dB -20 dBc
Power Supply Voltage 85-264 VAC
Power Supply Phases 3
Share on:
  • IEC/EN 61000-4-6
  • CISPR 24
  • EN 61000-6-1
  • EN 61000-6-2
  • IEC 60533
  • IEC 60601-1-2
  • IEC 61326
  • MIL STD 461
  • RTCA/DO 160
  • ISO 11452-3
  • ISO 11452-5
  • SAE J1113-24
Share on:

Teseq CBA 230M-080 Datasheet 

Amplifier Selection Table

Cross Reference to old model numbers

Share on:

* A confirmation will be send to your e-mail to validate a successful form subscription,
In case you did not receive confirmation e-mail please refill the form again or contact Accelonix directly.

Share on: