+31 40 7501650

Time Pressure Dispensing

Retrofit a Time Pressure Pump into your dispense system.

Time pressure is a versatile method of dispensing a wide range of material viscosities. Time pressure dispensing applies pressure pulses to a syringe. These timed pressure pulses are monitored by system software and a pressure controller.

Contact us

Time Pressure Liquid Dispensing Pump

Integrate versatile Time Pressure Liquid Dispensing Pump into benchtop equipment or automated dispensing system

Time pressure operation diagram

Time pressure is a versatile method of dispensing a wide range of material viscosities. Time pressure dispensing applies pressure pulses to a syringe. These timed pressure pulses are monitored by system software and a pressure controller.

  • Dispense fine and repeatable dots and lines
  • Great for short pot-life material
  • Good choice for hand-held operations
  • Suitable for wide range of fluid viscosities
  • All wetted parts are disposable

Integrate a Time Pressure System into Benchtop or Automated Dispense System

Integrate the Time Pressure Liquid Dispensing Pump into a fully automated Liquid Dispense Systems or a compact Benchtop equipment.

Monitor your Time Pressure Dispensing Pump with either a simple & versatile controller or an advanced FPC controller.

Share on:

Adjustable Pressure for Material and Flow Rate Variables

The amount of pressure used for a timed pressure process is determined by the relationship between the material being dispensed and the application flow rate.

Dots 0.011″ (0.27 mm) of structural and electrical conductive adhesives dispensed by Time Pressure Liquid Dispensing Pump.

When dispensing is finished, adjustable vacuum prevents syringe material from dripping. Adjustable vacuum prevents air from being pulled into the needle.

Time Pressure Liquid Dispensing prevents material drool when the pump is inactive by maintaining a proper level of vacuum to the syringe. This is especially useful when using low viscosity materials.

Simple. Disposable. Time Pressure Dispensing.

Use syringe sizes from 5 cc to 30 cc with the included syringe kit. An optional level detect is available.

Cleanup is simple. All wetted parts are disposable. An operator can change the syringe and needle plus re-calibrate the system within two (2) minutes.

Because material is dispensed directly from the syringe, empty syringes can be discarded. Commonly used Luer-Lok® type needles are also disposable.

Share on:

Share on:

Time Pressure for integration datasheet
FPC – Fluid Pressure Control information datasheet

Share on:

* A confirmation will be send to your e-mail to validate a successful form subscription,
In case you did not receive confirmation e-mail please refill the form again or contact Accelonix directly.

Share on: