Search

EM Test CN 200N Series

Trafo for LF conducted immunity

EM Test audio transformer assembly for LF conducted immunity testing

  • Frequency response 10 Hz to 500 kHz
  • Secondary saturation up to 300 A
  • Audio power 200 W per transformer
  • Turns ratio 2:1 step down

Quick Enquiry

If you want to know more about EM Test CN 200N Series
Trafo for LF conducted immunity

EMTest CN 200N – Single-box transformer assembly for LF conducted immunity testing

CN 200N Series – Single-box transformer assembly for LF conducted immunity testing The CN 200N Series is a standalone coupling network unifying up to three audio transformers, each with 100 A capacity, being configurable for various test requirements (e.g. LV 123, ISO/TS 7637-4 draft). The CN 200N Series is used to apply the test signals to the lines under test via an audio transformer to perform ripple voltage tests and continuous or transient conducted immunity tests.
  • AIRBUS
  • BMW GS 95023
  • Chrysler CS-11809 (2009)
  • DaimlerChrysler DC-10615
  • DO 160 Section 16
  • DO 160 Section 18
  • Ford EMC-CS-2009.1
  • Ford FMC1278
  • GLloyd VI-7-2
  • ISO 11452-10
  • Jaguar EMC-CS-2010JLR V1.1 (2011-01)
  • Jaguar JLR-EMC-CS V1.0 Amd 4
  • LV 123
  • MBN LV 123
  • MIL STD 461 D CS 101
  • MIL STD 461 D CS 109
  • MIL STD 461 E CS 101
  • MIL STD 461 E CS 109
  • MIL STD 461 F CS 101
  • MIL STD 461 F CS 109
  • MIL STD 461 G CS 101
  • MIL STD 461 G CS 109
  • MIL-STD-704
  • Mitsubishi ES-X82115
  • SAE J1113-2
  • Tata TST/TS/WI/257
  • VW 80300
  • VW 80303

 

CN 200N series – Fully contained coupling device as per LV 123

The CN 200N Series is an easy-to-use coupling device consisting of up to 3 audio transformers as required by LV 123 standard testing.

CN 200N1 – Fully contained coupling device as per Ford FMC1278

The CN 200N1 is an easy-to-use coupling device consisting of two audio transformers and a 0.5 ohm/250 watt load resistor configurable as required by Ford FMC1278, Fig. 22-6 for AC ground voltage offset testing. The two transformers need to be connected in series on their primary side, their secondary side is paralleled and loaded by the 0.5 ohm non-inductive resistor load

CN 200N Series Datasheet